Touchdown for O-Cell Test
The Los Angeles Memorial Coliseum was badly damaged by the Northridge earthquake. There was seven months to complete 3 years of work to be ready in time for football season. The project...

The Science of Water
The Foundation of Modern Hydraulics
The Science of Water, in a single volume, comprises 2,300 years worth of information on the evolution of hydraulic science. The book details...

In the Wet
The concept of using large diameter vertical cylinder piles of steel and concrete is not new. Vertical cylinders constructed in pneumatic caissons go back at least 70 years. Steel cylinders...

Engineering a Landslide
A slope failure in northwest Alabama has been stabilized using a system of grouted INSERT piles to provide load transfer across the failure surface of the slide. This system, referred...

Earthquake-Induced Movements and Seismic Remediation of Existing Foundations and Abutments
This proceedings, Earthquake-Induced Movements and Seismic Remediation of Existing Foundations and Abutments, contains papers presented at...

Failures in Civil Engineering
Structural, Foundation and Geoenvironmental Case Studies
This special publication consists of a collection of short descriptions of failures case studies in Civil Engineering. The descriptions cover cases in structural, foundation and geoenvironmental...

Foundation Upgrading and Repair for Infrastructure Improvement
This proceedings, Foundation Upgrading and Repair for Infrastructure Improvement consists of papers presented at the poster session held in...

Performance of Deep Foundations Under Seismic Loading
This proceedings, Performance of Deep Foundations Under Seismic Loading, consists of papers presented at a session of the 1995 ASCE Annual...

So Your Home Is Built on Expansive Soils
Prepared by the Shallow Foundations Committee of the Geotechnical Division of ASCE. This report assists homeowners in understanding why expansive soils...

A Primer on Micropiles
A major study of micropile technology has recently been funded by the Federal Highway Authority and completed by the authors. The subject is defined as a drilled and grouted, cast-in-place,...

The Foundation for a New Approach to Implement Building Innovation
Prepared by the Partnership for Building Innovation project, which is sponsored by CERF; National Institute of Standards and Technology; U.S. Department of Housing and Urban Development;...

Design of Mat Foundation for Egg Shape Digesters
Two levels of ground motion, the Maximum Probable Earthquake and the Maximum Credible Earthquake, were considered in designing the 2.5 million gallon egg shape digesters and their combined...

Coupling Translation and Rocking Motions
In the design of concrete block foundations for rotating and reciprocating machines, it is important to avoid resonant conditions. Therefore, accurate determination of the frequencies...

Case Study - Performance of Diaphragm Walls During Construction; Predictions vs. Field Measurements
Rigid diaphragm walls (slurry walls) are being used more than any other earth supporting system for underground construction projects in confined downtown sites throughout the United States...

Seismic Evaluation of the Tied-arch Bridge Across the Mississippi River on I-40
The bridge reported in this paper is a two-span steel tied-arch bridge supported on massive caisson foundations. Site specific seismic studies were carried out to establish the ground...

Site Effects on Strong Shaking and Seismic Risk: Recent Developments and Their Impact on Seismic Design Codes and Practice
The very strong influence of localized poor or 'adverse' geological/geotechnical foundation conditions on patterns and concentrations of damage during a number of recent earthquakes (e.g.:...

Guide for the Design of Prestressed Concrete Poles
With the aim of providing engineers with some basic tools and guidelines for the design of structures, the committee prepares code and policy changes, and to expand input of manufacturers...

Overview - Electrical Substation Structures Design Guide
The ASCE Substation Structures subcommittee of the Committee on Electrical Transmission Structures (CETS) is developing a substation structures design guide. The guide discusses the analysis...

SDC Detector Foundation Requirements for the SSC
The Solenoidal Detector Collaboration (SDC) detector weighs approximately 32,000 metric tons, and its ability to perform to design specifications is directly related to its internal alignment....

High-Strain Kinetic Testing of Deep Foundations
High-strain kinetic testing involves the upward decelerating or accelerating of a mass and using its inertial force to axial prolonged pulse at the head of a pile. Currently available...

 

 

 

 

Return to search